Air Gap Fitting For Water Softener. The purpose of an air gap is to ensure that water can only travel one way through the drain: It is designed to fit into recessed washing machine outlet boxes with 2 inches drainpipe.
Water Softener Air Gap for Installation in Washer Machine 2inch Drain from www.desertcart.ae
The two drain hoses require an air gap and cannot just be pushed into any. Splash guards are an integral part of the design and can be seen through the side air gap window. Keeney's air gap for standpipes is designed for washing machine discharge hoses, dehumidifiers, water filtration devices, water softeners, and appliance that drains into a standpipe.
It Prevents Contaminated Drain Water From Flowing Back Into The Water Softener.
It enables a ½ connection with a air break. Sand the edges of the cut pipe and use a lint free cloth to remove any dust and catch any leaking water with a bucket or container. There are tons of options online (they are hard to find at blowes and home despot), not sure which ones are more industry recommended.
An Air Gap Must Be Present.
Air gap device for water softener; Fill the brine tank with salt. I'm now fitting another softener that does not come with a fitting but also requires an air gap in the waste.
Keeney's Air Gap For Standpipes Is Designed For Washing Machine Discharge Hoses, Dehumidifiers, Water Filtration Devices, Water Softeners, And Appliance That Drains Into A Standpipe.
This water softener ½hose air gap kit is glued into the tap of the stand pipe. Buy in monthly payments with affirm on orders over $50. Do not make a direct connection to the drain.
See Reviews Photos Directions Phone Numbers And More For The Best Water.
Any ideas where i can get a fitting similar to this for a 1/2 or so hose, or how i can create an acceptable air gap. Here are the steps that we recommend you refer to after you install the water softener: The connection size for the two side inlets are 5/8 od, and the center outlet is 7/8 od to accept 7/8 id air gap to garbage disposal discharge hose.
It Is Designed To Fit Into Recessed Washing Machine Outlet Boxes With 2 Inches Drainpipe.
I was surprised at the force of the flow through the hose and not a drop of water out of the fitting. The waste pipe is classed as a. This water softener ½hose air gap kit is glued into the tap of the stand pipe.
Location:
Share :
Post a Comment
for "Air Gap Fitting For Water Softener"
Post a Comment for "Air Gap Fitting For Water Softener"